This is the matrix (height and width of your sign) plus the color of your sign (RG for tri-color sign and RGB or full for full color sign).
The “Type” depends on what type of sign you have. ID = 1 (and ID = 2 if you have a 2-sided sign) Name = Sign1 (and Sign2 If you have a two-sided sign) Make sure settings on the left hand side of the Sign Setup window are correct – as shown in the example here Go to “Sign Setup” (the “Sign Setup” window appears) On the upper left hand side of the software screen click on “File” These are the steps to set up the sign to communicate with SignX once again. In these cases the best course of action is to go through the Sign Setup process again. The SignX software may not have been setup properly initially or it may have gone back to default settings. If this is the case then follow the Troubleshooting steps in the “Sign Setup Issue” section below. You could possibly have the wrong Sign IP Information in your software.
0 kommentar(er)
